Keene

IR Commander Matrix

Overview

Setup
Connections
Configuration

- Options
- Factory Default
- Setup IR Codes
- Blast IR Codes
- Configuration
- Password
- Assign IP routing

Operation
Stand alone
Browser Control

Java Program
Java Software Program
IP_status
Learning IR Code Basic
Learning IR Code Adv
Learning IR Code Tips

Advanced
Macro commands
IP routing via macro
IR Translation & Routing via Learning Remote
UDP Port
Firmware Update
Dynamic DNS
Port Forwarding
RS232 Control
RS232 X10 Control
Shadowfile

Troubleshooting
Quick Checklist
Reset

Other
Optional Accessories
Third Party Software
Software Developers

Downloads
Firmware & Software

 

Last revised 12/3/12

Basic operation

The IR Commander Matrix can be used as a stand-alone hard-wired IR distribution system and configured and operated with no requirement for network operation.

An IR signal can be received either by the on-board IR receiver, or by an external receiver plugged into one of the input sockets or as data via the network connection. The signal once received is then transmitted to an IR wand connected to one or more of the outputs. The input routing switches determine which output (IR OUT 1,2,3 or4) receives the signal from that numbered input. The dip switch in the down position makes that output active. Any or all outputs may be active for each input.

To use the more advance features please download the software from the link opposite and then follow the instructions in the software control section.